Key Fob Keyless Entry Remote Shell Case & Pad fits Buick Century Regal Rendezvous/Oldsmobile Intrigue/Pontiac Aztek Grand Prix 2001 2002 2003 2004 2005

Work great

I'm so happy that I finally got a new case for my key fob. It never wanted to work right. It would take several tries but now it works on the first try. I recommend these from this company. I got exactly what I ordered. It arrived when it said it would and it was a great price.

exact match to replace the broken one

I bought this to replace the original FOB that had the attachment to Keychain broken. You have to take the guts out of your fob and put into this new one. While it worked, it is definitely not nearly as good material as your original. One issue I had was inserting the metal sleeve that puts pressure to hold the battery in place. Not really high quality and I actually had to cur the plastic metal holders with a razor blade as the slits were not precut for those very delicate flimsy metal piece. Would like to have exterior higher quality plastic and defiantly have the interior metal picece thick and sturdy like the original. But it did work after 3 attempts at assembly.

The original remote for my Buick Century was pretty much worn through and looked in danger of falling off the keyring. Remote worked fine, and I didn't want to go through the potential hassle of programming a totally new remote------all I needed was a new case, so I ordered this product.When I first tried to put my original remote circuit board into one of these new covers, I thought it was going to be impossible. The little metal battery contact (almost didn't notice it in the bag with the cover...) was not installed, and I tried for 15 minutes with tweezers to get it into the slots on the new cover. I thought I was going nuts, or that reviewers that gave this product 5 stars were nuts.Took a break and read through all of the reviews. THANK YOU to the reviewers who mentioned you have to use a safety razor blade to cut the plastic blocking the slots for the battery contact. Did that and the contact slid in fine!Next challenge (again THANK YOU to previous reviewers with this same problem): the circuit board from my original remote was just a hair too wide at one end to fit into the silicone key-pad cover. I tried putting the circuit board back into the original silicone cover and then tried to stuff it into the new shell. No Luck-----just like some other reviewers, I had to carefully shave just a bit off both sides of the "too fat" end of the circuit board (used a box cutter). Finally got it to fit into the new silicone keypad and then finally got it into the new case (took a bit of finagling with a thin screwdriver to get it to fully seat itself and get the lip of the silicone fully up around the circuit board)As a senior woman, It took a bit of strength to snap the halves of the new cover together, but finally got it!I thought that after all of this (shaving a circuit board---yikes!) there was no way the remote would work, but IT WORKED JUST FINE! And now I don't have to worry about the remote falling off the key ring!So, all in all, I am happy with my purchase.

This key fob she'll (you must have the electronic guts) basically is just as good as the original. It's a tight fit — had to really use care to get the circuit board in — but it did ultimately fit. Works great.

It did not fix right would like it returned back to you

Exactly what I needed and easy to just move my old mother board into the case , so no reprogramming and good quality for price and arrived a bit early . Recommend and will be ordering another one so I’ll have two in the future ✅🤗