MARASTAR 00232-2PK Universal Fit Flat-Free 11x4.00-5 Tire and Wheel Assembly, Zero Turn Lawn Mower Replacement Tires, Smooth Tread, Adapter Kit included, 2 pack

Wheels were a good replacement. Easy to install. Work well.

I finally became aggravated with my front tires never being fully inflated or completely off the rim. I looked at inner tubes and locally they were $25 or more a piece. These just made a lot more sense financially and practically. I ordered the bearings to go with these but they are still floating around somewhere out there in The ether, so I reused the original bearings by cleaning them out and repacking them with grease and they fit and work just great. I had to use the thick spacers to fit this to my Kubota.A couple of things about the difference is I immediately noticed:1. Ouch!! I'm looking for a new seat cushion now. The ride is substantially rougher than inflated tires. For me it's not a huge factor as I only use it every couple of weeks for a few hours, but if I were riding this thing professionally day in and day out, I believe I would rather have the original inflated tires.2. Handling is more precise it seems and turns are a little bit faster and easier, but this is probably because I never had the other tires inflated like they should have been in the first place.3. Downhill, which we all know is a No-No, is a little more dicey and more difficult to control with the slick hard front tires.4. The general appearance and overall cut off my grass was much improved!

Very easy to install. Perfect fit.

So tired of front flats on Husqvarna zero turn mower on 4 acres of yards.These arrived early. Well packed.Both zerk fittings were loose. I removed the installed ones and replaced them with better quality 1/4x28 angle fittings with the threads teflon tape wrapped. The zerk fitting holes in the hub are in very thin metal thus no real depth for more than one thread. The holes appeared almost as if untapped with the zerks self-threaded in the thin metal (-1 Star). New ones seem to hold and are tighter fitting. Tighten once only as they do self-thread when you put them in.Tires seem to be good quality as are the nylon spacers. Bushings installed are 3/4 ID but 5/8 ID are included if you need to change. TIme will tell about durability.Update on ride quality: I have cut 2 separate yards (~ 4 acres total) twice since installing these tires. These are yards located on rural properties and have evolved to their present condition over many years of nothing more than routine cutting of the grass. My experience so far is that these tires do provide a slightly rougher ride when they run over a small obstacle (protruding root top, hummock in surface, etc). however the roughness is by no means troubling, It is one of those things you will notice - similar to when you increase tire pressure. Otherwise, no change.For our use and our yard conditions we are very satisfied so far. Old yards are chock full of decades of buried broken glass, nails, metal shards, bottle caps, etc. Front tire cuts and flats on our zero turns was a problem we continually fought. So far-so good. We don't see very much impact damage to the tire surfaces as we did with the softer pneumatic tires. But again, time will be the judge.

Good value, holding up well for 2 years. Solid tire so they never go flat.

It worked great as a tire replacement!

First the bad: if you have a bad back, this is going to make the ride so much worse on uneven terrainNow the good: These turn better than the stock ever did and never lose air. I can even take the turns a little quicker without losing the evenness of the cutDefinitely recommend, but not for those with bad backs because the ride is rough on uneven terrain

The tires may hold up longer but as others have stated there is a different feel than the tubes tires. They is a noticeably harder ride than the tubed tires. Would I buy them again no but others might be good with a stiffer ride.